Filter
Top Products
Configuration Commands
137
Table 110 Spanning Tree Port Configuration commands
Command Description
[no] spanning-tree stp
{<1-128>} edge
Enables or disables this port as an edge port. An edge port is not
connected to a bridge, and can begin forwarding traffic as soon as the
link is up. Configure server ports as edge ports (enabled).
This command only applies when RSTP is turned on. See the “Common
Internal Spanning Tree configuration” section for more information.
Command mode: Interface port
spanning-tree stp {<1-128>}
fastforward
Enables or disables Port Fast Forward on the port.
Command mode: Interface port
spanning-tree stp {<1-128>}
enable
Enables STP on the port.
Command mode: Interface port
no spanning-tree stp
{<1-128>} enable
Disables STP on the port.
Command mode: Interface port
show interface port {<port
number>} spanning-tree stp
{<1-128>}
Displays the current STP port parameters.
Command mode: All
Forwarding Database configuration
The following table describes the Forwarding Database Configuration commands.
Table 111 FDB Configuration commands
Command Description
aging <0-65535>
Configures the aging value for FDB entries. The default value is 300.
show mac-address-table
Displays current FDB parameters.
Static FDB configuration
The following table describes the Static FDB Configuration commands.
Table 112 Static FDB Configuration commands
Command Description
mac-address-table static
[<MAC address> vlan <VLAN>
port <port>]
Adds a static entry to the forwarding database.
Command mode: Global configuration
no mac-address-table static
[<MAC address>| all]
Deletes a static entry from the forwarding database.
Command mode: Global configuration