Filter
Top Products
Configuration Commands
176
Re-Mark Update User Priority configuration
The following table describes the Update User Priority Configuration commands.
Table 163 ACL Update User Priority Configuration commands
Command Description
access-control list <1-384>
re-mark in-profile dot1p <0-7>
Defines 802.1p value. The value is the priority bits information in
the packet structure.
Command mode: Global configuration
[no] access-control list <1-384>
re-mark in-profile use-tos-
precedence
Enable or disable mapping of TOS (Type of Service) priority to
802.1p priority for In-Profile packets. When enabled, the TOS
value is used to set the 802.1p value.
Command mode: Global configuration
default access-control list
<1-384> re-mark
Resets UP1P settings to their default values.
Command mode: Global configuration
show access-control list <1-384>
re-mark
Displays the current ACL re-mark parameters.
Command mode: All except User EXEC
ACL Re-mark Out-of-Profile configuration
The following table describes the Re-mark Out-of-Profile Configuration commands.
Table 164 ACL Re-mark Out-of-Profile Configuration commands
Command Description
access-control list <1-384>
re-mark out-profile dscp
<0-63>
Sets the DiffServ Code Point (DSCP) of Out-of-Profile packets to the
selected value. The switch sets the DSCP value on Out-of-Profile packets.
Command mode: Global configuration
default access-control list
<1-384> re-mark
Resets the update DSCP parameters for Out-of-Profile packets to their
default values.
Command mode: Global configuration
show access-control list
<1-384> re-mark
Displays the current ACL re-mark parameters.
Command mode: All except User EXEC