Filter
Top Products
Configuration Commands
149
RIP Interface configuration
The RIP commands are used for configuring Routing Information Protocol parameters. This option is turned
off by default.
NOTE: Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interface Configuration commands.
Table 129 RIP Interface Configuration commands
Command Description
ip rip version {1|2|both}
Configures the RIP version used by this interface.
The default value is version 2.
Command mode: Interface IP
[no] ip rip supply
When enabled, the switch supplies routes to other routers. This
command is enabled by default.
Command mode: Interface IP
[no] ip rip listen
When enabled, the switch learns routes from other routers. This
command is enabled by default.
Command mode: Interface IP
[no] ip rip poison
When enabled, the switch uses split horizon with poisoned reverse.
When disabled, the switch uses only split horizon. This command is
disabled by default.
Command mode: Interface IP
[no] ip rip split-horizon
Enables or disables split horizon. The default value is enabled.
[no] ip rip triggered
Enables or disables Triggered Updates. Triggered Updates are used
to speed convergence. When enabled, Triggered Updates force a
router to send update messages immediately, even if it is not yet time
for the update message. The default value is disabled.
Command mode: Interface IP
[no] ip rip multicast-updates
Enables or disables multicast updates of the routing table (using
address 224.0.0.9). The default value is enabled.
Command mode: Interface IP
[no] ip rip default-action
{none|listen|supply|both}
When enabled, the switch accepts RIP default routes from other
routers, but gives them lower priority than configured default
gateways. When disabled, the switch rejects RIP default routes.
The default value is disabled.
Command mode: Interface IP
[no] ip rip metric {<1-15>}
Configures the route metric, which indicates the relative distance to
the destination. The default value is 1.
Command mode: Interface IP
[no] ip rip authentication type
{<password>}
Configures the authentication type. The default is none.
Command mode: Interface IP