Filter
Top Products
Configuration Commands
143
Table 119 IP Interface Configuration commands
Command Description
no enable
Disables this IP interface.
Command mode: Interface IP
no interface ip {<1-250>}
Removes this IP interface.
Command mode: Global configuration
show interface ip {<1-250>}
Displays the current interface settings.
Command mode: All
NOTE: If you enter an IP address for interface 1, you are prompted to change the BOOTP setting.
Default Gateway configuration
The switch supports up to four gateways, plus management gateway 254. By default, no gateways are
configured on the switch. Enter 1, 2, 3, 4, or 254 in the command as the ip gateway instance,
depending upon which gateway you want to configure.
The following table describes the Default IP Gateway Configuration commands.
Table 120 Default IP Gateway Configuration commands
Command Description
ip gateway {<1-4, 254>}
address {<IP address>}
Configures the IP address of the default IP gateway using dotted decimal
notation.
Command mode: Global configuration
ip gateway {<1-4, 254>}
interval {<0-60>}
The switch pings the default gateway to verify that it is up. This option sets the
time between health checks. The range is from 0 to 60 seconds. The default is
2 seconds.
Command mode: Global configuration
ip gateway {<1-4, 254>}
retry {<1-120>}
Sets the number of failed health check attempts required before declaring this
default gateway inoperative. The range is from 1 to 120 attempts. The default
is 8 attempts.
Command mode: Global configuration
[no] ip gateway {<1-4,
254>} arp-health-check
Enables or disables Address Resolution Protocol (ARP) health checks. This
command is disabled by default.
Command mode: Global configuration
ip gateway {<1-4, 254>}
enable
Enables the gateway for use.
Command mode: Global configuration
no ip gateway {<1-4,
254>} enable
Disables the gateway.
Command mode: Global configuration
no ip gateway {<1-4,
254>}
Deletes the gateway from the configuration.
Command mode: Global configuration
show ip gateway {<1-4,
254>}
Displays the current gateway settings.
Command mode: All except User EXEC