Filter
Top Products
Removal and replacement procedures 65
11.
Remove the mini-DIMM, if installed.
12. Remove the HP NC524SFP Dual Port 10GbE Module ("HP NC524SFP Dual Port 10GbE Module" on
page 65), if installed.
To replace the component, reverse the removal procedure.
HP NC524SFP Dual Port 10GbE Module
To remove the component:
1. Power down the server (on page 27).
2. Disconnect the network cables.
3. Do one of the following:
o Open or remove the tower bezel, as needed ("Tower bezel" on page 30).
o Extend the server from the rack (on page 28).
4. Remove the access panel ("Access panel" on page 31).
5. Remove fan 5 ("Fan 5" on page 31).
6. If installed, remove the BBWC battery pack or the FBWC capacitor pack ("BBWC battery pack or
FBWC capacitor pack" on page 33).
7. Remove the air baffle ("Air baffle" on page 34).
8. Using a T-15 Torx screwdriver, remove the retaining screw.