Filter
Top Products
Removal and replacement procedures 68
9.
Remove the Systems Insight Display cables from the system board.
To replace the component, reverse the removal procedure.
I/O bezel
To remove the component:
1. Power down the server (on page 27).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Tower bezel" on page 30).
o Extend the server from the rack (on page 28).
3. Remove the access panel ("Access panel" on page 31).
4. Remove fan 5 ("Fan 5" on page 31).
5. If installed, remove the BBWC battery pack or the FBWC capacitor pack ("BBWC battery pack or
FBWC capacitor pack" on page 33).
6. Remove the air baffle ("Air baffle" on page 34).
7. Remove the fan cage ("Fan cage" on page 35).
8. Extend the I/O bezel from the chassis.
The cages, blanks, and drives are not shown for clarity.
9. Disconnect the cables from the I/O bezel.
10. Remove the I/O bezel.
To replace the component, reverse the removal procedure.
I/O bezel cables
To remove the component:
1. Power down the server (on page 27).
2. Do one of the following: