Filter
Top Products
Removal and replacement procedures 43
o
Slide the server back into the rack.
7. Power up the server.
Standard hard drive cage backplane
To remove the component:
1. Power down the server (on page 27).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Front bezel" on page 30).
o Extend the server from the rack (on page 28).
3. Place the tower server on its side.
4. Remove the access panel ("Access panel" on page 31).
5. Disconnect all cables from the rear of the hard drive cage.
6. Remove the hard drive cage ("Standard hard drive cage" on page 39).
7. Remove all hard drives ("SAS/SATA hard drive" on page 38).
8. Remove the hard drive cage backplane:
o Six-bay LFF hard drive cage backplane