Filter
Top Products
Removal and replacement procedures 65
6.
Close the heatsink locking levers.
7. Install the large redundant fan air baffle, if removed.
8. Install the access panel.
9. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
10. Power up the server.
System board
To remove the component:
1. Power down the server (on page 27).
2. Do one of the following:
o Open or remove the tower bezel, as needed ("Front bezel" on page 30).
o Extend the server from the rack (on page 28).
3. Remove the access panel ("Access panel" on page 31).
4. Disconnect all cables connected to the system board ("System board components" on page 83).
5. Remove all expansion boards ("Expansion board" on page 45).
6. Remove the large redundant fan air baffle, if installed ("Large redundant fan air baffle" on page 33).
7. Remove the DIMM baffles ("DIMM baffle" on page 34).
8. Remove all fans ("Fan" on page 35).
9. Remove all DIMMs ("DIMM" on page 56).
10. Remove the battery-backed write cache module, if installed ("Battery-backed write cache module" on
page 47).