Filter
Top Products
(004 intentionally excluded)
5-8 Diagnostic Tests
008 Jogging Motor Test
1 Go to: 008
2 Press: READY to run the test. The output tray jogs back and forth.
3 Confirm that a tone sounds each time the tray contacts the sensor at each side.
The codes in the following table indicate specific error conditions:
4 Press: STOP to exit.
009 Photoconductor Test
1 Go to: 009
2 Press: READY to run the test. The main motor rotates the photoconductor belt.
3 Confirm that a tone sounds repeatedly, indicating that the photoconductor belt is rotating.
These codes may indicate specific error conditions:
4 Press: STOP to exit
Table 5-4. Jogging Motor Test Error Displays
Display Indication
081 Front tray sensor signal not received
082 Rear tray sensor signal not received
083 No signal received from either sensor
090 Close covers
Table 5-5. Photoconductor Error Test Displays
Display Indication
030 Developer bias short detected
040 Photoconductor seam sensor not
received or detected
041 Seam sensor (sender) short
042 Seam sensor (sender) open or the
photoconductor is not installed
055 Erase lamp malfunction