Filter
Top Products
3.9 Operating the Storage Device
3-72
5
To select a data to read, press the ENTER key. A blinking question mark (
?
) appears
before the data name.
6
Press the U or V key to scroll through the data in the storage device.
7
When the desired data is indicated, press the ENTER key. The message display shows
Processing as the data is read from the storage device.
Writing Data to a memory card or the hard disk
You can write data to a memory card or the hard disk using the operator panel. When writing
data to the storage device, a name is automatically assigned to the data. The memory card or
the hard disk must be formatted. Otherwise, the >Write Data message explained below
will not appear on the display. To format a memory card or the hard disk, see Formatting a
Storage Device on page 3-75.
Note
You can format the hard disk using the operator panel when the first time you installed a
new hard disk. About formatting a new hard disk, see also the Installation Guide of the
hard disk for details.
After writing is complete, you can print a list of data stored in the storage device for
confirmation. See Printing a Partition List on page 3-76.
To write data to a memory card or the hard disk, proceed as follows:
1
Press the MENU key.
2
Press the U or V key repeatedly until Memory Card > or Hard disk > appears.
3
Press the Z key.
4
Press the U or V key repeatedly until >Write Data appears.
>Read Data
?DataS002
Memory Card >
>Write Data