Filter
Top Products
A.3 General Description of Options
A-12
A.3.8 HD-3 Hard Disk
The HD-3 hard disk is provided as a standard accessory for the FS-8000CN printer.
The HD-3 is a hard disk for storing print data and electronic sorting as controlled by the
printer driver. You can use the KM-NET Printer Disk Manager utility to keep track of the
stored data. This software is included in the CD-ROM supplied with the printer.
The hard disk is installed in the OPT2/HDD (upper) slot provided for it at the back of the
printer as shown below.
The hard disk must be formatted before the initial use. To format the hard disk, use the
printer operator panel or the KM-NET Printer Disk Manager. Before you install the hard
disk in the printer, power off the printer and unplug the power cord.
Figure A-15
Caution
• Do not install the hard disk in the OPT1 (lower) slot.
• This printer remains energized for 30 minutes even after it is powerd off
for internal cooling. Unplug the power cord before installing the hard disk
in the printer. Power on the printer immediately after you finish the hard
disk installation.
A.3.9 BC-1 Barcode Reader
The barcode reader allows your printer to use bar codes for the management of stored print
jobs. This barcode reader is connected to the printer’s serial interface.
Figure A-16
OPT2/HDD Slot
Serial Connector