Filter
Top Products
3.5 Changing the Interface Parameters
3-41
Press the U or V key to scroll through values. When
115200
is displayed, press the ENTER
key. Press the MODE key to exit the menu selection.
Note
Some computers may not be able to handle a baud rate of 115200 bps. If you set the
baud rate to 115200 and encounter communication problems, select a lower baud rate.
3.5.3 Changing Network Interface Parameters
This section applies to the FS-8000C series printers having the network interface card
installed. The FS-8000CN comes equipped with a network interface card as a standard
accessory. For details concerning network issues when using the FS-8000CN, refer to the
supplied manual for the network interface card.
Using the operator panel, you can:
• Activate or deactivate TCP/IP, NetWare, and AppleTalk
• Activate or deactivate DHCP
• Enter IP address, subnet mask address, and default gateway address
• Determine whether to print a network status page when the printer is turned on
To confirm or change network card parameters, proceed as follows:
1
Press the MENU key.
2
Press the U or V key repeatedly until Interface > appears.
3
If the current interface is other than option, press the ENTER key. A blinking question
mark (?) appears.
4
Press the U or V key repeatedly until Option appears.
5
Press the ENTER key again.
6
Press the Z key. One of the following menus is indicated. To change settings for the
item, press the ENTER key. Use the U or V key to change the value or selection.
Interface >
? Parallel
Interface >
? Option 1