Filter
Top Products
7 Select Group Run from the upper right corner of the display.
After the measurement is complete, you can interleave the trace lists of both
state analyzers to see the activity executed by both coprocessors during
related clock cycles.
You can use a similar procedure if you have only one processor, but wish to
monitor its activity with that of other system nodes, such as chip-select lines,
I/O activity, or behavior of a watchdog timer. In some instances it may be
easier to look at related activity with a timing analyzer.
See Also “Special Displays” in this chapter.
“To use a state analyzer to trigger timing analysis of a count-down on a set of
data lines” in this chapter.
Intermodule Measurements
To monitor the activity of two coprocessors in a target system
2–20