Filter
Top Products
1-2
Installing the Hub
Installing and Configuring Your Hub
Installing the Hub
Installing and Configuring Your Hub
To install and configure your hub, you must complete five basic tasks. They
are:
■ locating and verifying the necessary parts
■ connecting an external transceiver (if necessary)
■ connecting the hub to a power source
■ mounting the hub
■ connecting the hub to your network
1. Verify included parts
Each Hub-16M has the following components shipped with it:
■ HP 10Base-T Hub-16M (J3188A) Installation and Reference Guide—
this manual (J3188-90001)
■ A U.S./Canada/Mexico (8120-1378) power cord.
■ Accessory kit (5064-2053):
• bumper feet (4)
• hub-to-rack screws 10-32 (4)
• bracket-to-hub screws 10-32 (4)
• nylon finishing washer (4)
• bracket-to-hub screws (2)
• AUI retainer assembly
2. Connect the external transceiver
Because of the way the external transceiver protrudes out from hub once it is
connected, you may want to install the external transceiver before installing
the hub. Inspect your installation site and identify whether enough room will
be available for the external transceiver to be connected. Then see your
external transceiver guide for installation instructions.
3. Verify the hub operates correctly
Before mounting the hub, connect it to a power source and verify the hub will
operate correctly.
MUCHO.BK : ch1.fm5 Page 2 Thursday, June 26, 1997 11:37 AM