Filter
Top Products
3-20
Managing the Hub
Console Command Reference
Managing the Hub
■ Redundant Power Supply status:
• NOT CONNECTED means the RPS is not attached to the device.
• CONNECTED/FAULT means the RPS is attached but is reporting an
error.
• CONNECTED/GOOD means the RPS is attached with no errors, but
has not been enabled.
• CONNECTED/GOOD/ACTIVE means the RPS is attached with no
errors, and is active (the primary power supply is not operating and
the RPS has been initiated as a backup system).
■ a table with the port information described as follows:
Status
Information
What It Means
Port The port ID. (Additionally, bkup indicates that the port is configured as the
backup link, pri indicates that the port is the primary link—see the Backup
command).
Port Status The status of each port:
ON means the port is enabled and is not auto-segmented.
OFF means that the port has been disabled by the Port command or
because of a security violation.
PARTITIONED means the port has been auto-partitioned.
(See “Auto-Partitioning” in the
chapter that provides information on the
Product Description.
)
ON/REVERSED means that reversed wiring polarity on the receive pair has
been detected on a twisted-pair cable and the hub has compensated.
Link Beat Informs the hub of the presence of a device connected to it over twisted-
pair cable.
MAC address The unique 12-digit link-layer address for the hub. (Also called Ethernet
address or physical address.)
INTRUDER
ADDRESS
The address of a device not authorized to access the hub.
MUCHO.BK : ch3.fm5 Page 20 Thursday, June 26, 1997 11:37 AM