HP (Hewlett-Packard) LC 2000 Server User Manual


 
Chapter 2 Controls, Ports, and Indicators
18
Applying Power to the HP NetServer
Powering Up the HP NetServer
1. Ensure the HP NetServer’s power cord or power cords are connected to the
power source. See Figure 2-4.
2. Press the Power button on the front control panel. See Figure 2-1 or 2-2.
NOTE Each time AC power is applied (power cord is plugged in),
there is a 15 second delay (self test) before the front control
panel will respond to your actions.
Powering Down the HP NetServer
1. Log off all users and, if necessary, back-up files.
2. Follow instructions in your network operating system (NOS)
documentation to gracefully shut down all networking software and
applications.
3. Press the power switch on the HP NetServer’s control panel when
prompted by the operating system.
Normally, this completes the shutdown procedure.
NOTE The power supply will continue to provide standby voltage to
the HP NetServer until the power cord(s) is/are disconnected.
Connecting AC Power to Multiple-Server Configurations
The HP NetServer temporarily draws a large "inrush current," when first
connected to an AC power source. This also occurs when the NetServer is in a
standby mode (power is turned off and the power cord is plugged into AC power).
The inrush current is much greater than the NetServer’s normal operating current
and generally, the AC power source can handle the normal inrush current.
However, if you install several HP NetServers on one circuit, precautions are
necessary. If there is a power failure and power is then restored, all the servers
immediately begin to draw inrush current at the same time. If the circuit breakers
on the incoming power line have insufficient capability, the breaker may trip and
thus prevent the servers from powering up.
When preparing your site for installation, allow for the additional inrush current.
See "Power Requirements" in Appendix A.