Filter
Top Products
Chapter 4 Installing Mass Storage Devices
46
Installing Hot Swap Hard Drives
Use this section to install Hot Swap hard drives in the Hot Swap drive cage.
CAUTION Protect the drive from static electricity by leaving it in its
anti-static bag until you are ready to install it. Before handling
the drive, touch any unpainted metal surface to discharge
static electricity. When you remove the drive from the
anti-static bag, handle it only by the frame.
Do not touch the electrical components. Place the drive on the
anti-static bag whenever you set it down.
1. Unlock the Hot Swap Mass Storage Cage with the key provided before
attempting to remove the drive spacer or filler panels.
2. Remove any filler panels in the desired disk drive location:
a. Press in the locking latch and insert your fingers.
b. Using your fingers, pull the filler plug straight out. See Figure 4-8.
Figure 4-8. Removing Filler Panel from Cage