Filter
Top Products
Chapter 4 Installing Mass Storage Devices
34
Drive Bay Shelves
The non-hot swap drives include the IDE CD-ROM and the 3.5 inch flexible disk
drives which are standard for all HP NetServer models (LC 2000/2000r) and ship
with each unit. The two empty drive shelves beneath the CD ROM drive support
other non-hot swap SCSI devices, such as hard drives (3.5-inch or 5.25-inch), tape
back-up devices, or other HP-tested (LVD or SE) SCSI accessories.
The system chassis ships with a Hot Swap Mass Storage cage supporting up to six
low-profile Hot Swap hard drives or three half-height Hot Swap hard drives.
CD-ROM
Flexible
Disk
Drive
Hot-Swap
Hard Drive
Shelves (6)
Non-Hot Swap
Drive Shelves
Non-Hot
Swap
Drives
Figure 4-1. Standard Mass Storage Configuration
Boot Priority
This section details the HP NetServer’s boot order by highest to lowest priority.
The on-board SCSI controller has two channels, A and B. Channel A is typically
used to control the Hot Swap SCSI drives. Channel B is typically used to control
the internal non-hot swap SCSI drives. On each SCSI channel, the NetServer
scans for a boot device starting at device ID 0 and proceeds up from there.
The HP NetServer’s boot order (BIOS search order for a boot device) should be
considered, when connecting cables from the on board SCSI channels. A SCSI
drive’s boot priority is set by the drive’s location in the boot order. See Figure 4-1.