HP (Hewlett-Packard) LC 2000 Server User Manual


 
Chapter 7 Installing Additional Processors
73
Installing the Processor
The installation procedure is the same for the rack-mounted models as for the
pedestal models of the NetServer once you gain access to the system board.
CAUTION Use an anti-static wrist strap and a grounding mat.
Wear a wrist-strap and use a static-dissipating work surface
connected to the chassis when handling components. Ensure
the metal of the wrist strap contacts your skin.
1. Unpack the processor shipping box and check the contents against its
packing list.
CAUTION Do not remove the processor from its bag until you are ready
to install it and ensure the bag remains sealed until then.
2. Gracefully shut down the network operating system according to directions
in your NOS documentation.
3. Press the power switch on the HP NetServer’s control panel when
prompted by the operating system.
Normally, this completes the shutdown procedure.
4. Disconnect the power cord or power cords.
WARNING Power supplies will continue to provide standby current to the
NetServer until the power cables are disconnected.
5. To gain access to the system board, follow the appropriate instructions for
removing the cover.
If the NetServer is mounted on the pedestal, perform Steps 1-8 in the
"Removing Covers – Pedestal (LC 2000)" in Chapter 3, "Opening and
Closing the HP NetServer," to gain access to the NetServer.
NOTE It is not necessary to remove the system board from the
NetServer to install the new processor module or the VRM.
If the NetServer is in the rack, perform steps 1-14 in the "Removing
Covers – Rack Mount (LC 2000r)" in Chapter 3, "Opening and Closing
the HP NetServer," to gain access to the NetServer.