Filter
Top Products
Chapter 1 Server Administration Using HP TopTools
8
6. If the left P (Power) LED is turned off (gray), go to the next section,
"Removing a Hot Plug Board" to remove the PCI Hot Plug board.
Removing a Hot Plug Board
Use this topic to physically remove a PCI Hot Plug Board from the slot.
1. At the front of the NetServer, remove the front bezel from the HP
NetServer (refer to your Installation Guide).
2. Extend the HP NetServer chassis safely from the rack (refer to your
Installation Guide).
3. Remove the PCI Access Panel (refer to your Installation Guide).
CAUTION Do not drop screws or other metal objects into the HP
NetServer.
4. Verify power to the desired PCI slot is turned off, by checking the desired
PCI slot's Power LED (right) on the rear panel is off (gray).
The right green Power LED must be OFF. See Figure 7 and Table 1.
5. If not, go back to the section "Powering Down a PCI Slot" and verify you
have turned off power to the correct slot.
6. If you are unable to power down the slot, remove and install the PCI board
in the PCI slot as described in the Installation Guide.
CAUTION To prevent a possible system crash or hang do not continue
with this procedure if you are unable to turn off power to the
PCI slot.