Filter
Top Products
Appendix B Warranty, Software License and Support
18
The rear of the chassis provides two LEDs for each PCI Hot Plug slot to indicate
its status. The LED indicators are related to the status shown in the user interfaces'
main menu. The following table decodes the LEDs for each PCI slot. See Table 2
and Figure 14.
NOTE If the user interface, Novell Configuration Manager Console
(NCMCON), displays a No in the “Hot Plug” column for each
PCI (P1-P10) slot, then the correct hot plug controller driver
(phpsbd.nlm) is not loaded. See Figure 14 and the Help files.
Table 2. PCI (Hot Plug) LED Indicators (rear view)
Amber
LED
Green
LED
Slot
Status
Indicates This Status
Off On Ready Powered on, but no driver loaded for board. Do not
remove the board from the slot.
Powered On The PCI slot just power on, but the driver initiation is
not complete yet. This only happens momentarily prior
to completing driver loading. Do not remove the board
from the slot.
Active Power to the slot is on, and the slot is operating
normally. Do not remove the board from the slot.
On Off Powered
Off (wrong
board or no
board)
Power to the slot is off, but the Amber LED is on, due
to a failure in the Hot Replacement process. Typically
this is the result of installing the wrong board, because
the replacement board must be the same type as the
original PCI board. This also occurs if the board is
removed, emptying the slot, and power is turned on.
You can safely remove the board from this slot.
Off Off Powered
Off
Power to the slot is off. You can remove the board from
this slot.