Filter
Top Products
Chapter 1 Server Administration Using HP TopTools
10
NOTE Ensure you label any cables attached to the PCI board (disk
controller, NIC, etc.), to identify it later when connecting the
cable to the new or replacement PCI board.
9. Release the PCI hold-down latch to remove the board from the PCI slot.
a. Press the center of the PCI hold-down latch (should hear a click).
See Figure 8.
b. Pull the latch to half open (allows the board to clear the latch).
See Figure 8.
A. Push here
to release
(should click).
B. Pull latch
to half open from rear.
Figure 8. Releasing the PCI Board
NOTE The HP NetServer is shown with its top cover removed for
clarity. Only the PCI Access Panel should be removed for this
procedure. See Step 3.