Filter
Top Products
Chapter 2 PCI Hot Plug Utility for Novell NetWare
35
The PCI hold-down latch is used to keep the PCI boards in place and to
activate the PCI slot power switch and PCI LED board.
NOTE The HP NetServer is shown with its top cover removed for
clarity. Only the PCI Access Panel should be removed for this
procedure.
9. Open the PCI board-guide latch before removing the PCI board. See Figure
26.
CAUTION Do not bend the PCI board to remove it from the slot.
If the PCI board is full-length, the PCI board guide latch at the
rear of the PCI slot is used to hold the board in place. The
latch at the top of PCI board guide prevents the board from
moving during HP NetServer transportation and handling
when performing PCI Hot Plug operations.
PCI Board
Guide Latch
Open Latch
Figure 26. PCI Board Guide Latch