Filter
Top Products
Hardware options installation 62
9. Connect the USB tape drive cable to the rear of the drive and to the USB tape drive connector on the
system board.
10. Remove the applicable bezel blank from the bezel ("Remove a bezel blank" on page 24).
11. Install the access panel (on page 22).
12. Do one of the following:
o Close or install the tower bezel, as needed.
o Slide the server back into the rack.
13. Power up the server (on page 20).
Full-height tape drive option
For clarity, the following illustrations include option cabling only.
To install the component:
1. Power down the server (on page 20).
2. Do one of the following:
o Unlock and remove the bezel ("Open or remove the tower bezel" on page 20).
o Extend the server from the rack (on page 21).
3. Remove the access panel (on page 21).
4. Remove the applicable media bay blanks ("Remove the media bay blank" on page 23).
IMPORTANT: For correct cabling, install the full-height tape drive in the top two slots.
5. Identify the guide screws ("Identifying guide screws" on page 58).