Filter
Top Products
Service Manual Removal and Replacement 2-31
7. Position the notebook so the front faces forward.
8. Disconnect the floppy drive flex cable from the low insertion force (LIF) connector to which it is
connected.
9. Release the ZIF connector to which the TouchPad cable is connected, and then disconnect the
TouchPad cable from the system board.
10. Remove the following 4 screws:
•
One M2.5×7.0mm screw next to the TouchPad cable
• Two M2.5×6.0mm screws in the center of the top case
• One M2.5×4.0mm screw on the right side of the top case
CAUTION: The 4 screws removed in step 10 are 3 different lengths. Be sure to note of the
correct location of each screw as it is removed and install it in the correct location. Failure to
follow this caution can result in damage to the notebook.
11. Lift the top case off of the notebook.
Figure 2-21. Removing the Top Case
HP Pavilion ze5x00,
HP nx9010 and HP nx9008, and
Compaq Presario 2500 Models