Filter
Top Products
Introduction
This chapter describes various printer settings that the printer administrator may wish to control as
soon as a new printer is assembled and ready for use.
Paper suitability options (T1200 series only)
Paper mismatch action
If the paper currently loaded in the printer is not suitable for a particular job, the printer can either put
the job on hold until some suitable paper is loaded, or it can ignore the problem and print the job on
the unsuitable paper. There are several ways in which the loaded paper may be considered
unsuitable:
●
The paper type is not as specified for the job
●
The paper source (roll 1, roll 2 or sheet) is not as specified for the job
●
The paper size is smaller than specified for the job
You can set the printer's behavior in such cases from the front panel.
●
Select the Setup menu icon
, then Job management options > Paper mismatch action >
Print anyway if you want such jobs to print on whatever paper is loaded. This is the default
option.
●
Select the Setup menu icon
, then Job management options > Paper mismatch action >
Put job on hold if you want such jobs to be put on hold. The printer will send an alert whenever
a job is put on hold.
When a job is put on hold for paper, it is kept in the printer queue until some suitable paper is loaded
(in which case, all jobs waiting for that paper type can be printed). Meanwhile, other jobs with different
requirements can continue printing.
Roll switching options
If two rolls are loaded, both of which are suitable for the job, the roll will be chosen according to your
preferences. These can be set from the front panel: select the Setup menu icon
, then Printing
preferences > Paper options > Roll switching options. There are three available options:
●
Minimize paper waste. If this option is chosen, the printer will choose the narrowest roll that
meets all the criteria, to avoid wasting paper due to trimming. This is the default option.
●
Minimize roll changes. If this option is chosen, the printer will choose the roll that is currently
active, to avoid wasting time with a roll switch. To change the active roll, select the Paper menu
icon
, then Select active roll.
●
Use roll with less paper. If this option is chosen, the printer will choose the roll that has the
least paper.
NOTE: This option is effective only if you have enabled Printing paper info (see Printing
paper info on page 43). Otherwise, it has the same effect as Minimize paper waste.
ENWW Introduction 21
Administrator settings