Filter
Top Products
93
Chapter 3, Processing Calls
Registration
Processing Calls
Registration
See “Program Example” on page 149 for an example of the program command.
1. Verify that you have already done the following (refer to “Configure the Test Set to
Emulate a Base Station” on page 64
):
• Zeroed the RF Power meter to your satisfaction.
• Selected the proper audio filter, if you want to test audio.
• Put the Test Set in Active state.
• Connected the mobile to the Test Set and turned the mobile’s power on.
2. Select
Data
from the
Data/Meas
field. (This is the default mode)
3. Select
Register
from the list on the left side of the screen.
4. If the registration message has been received, the Test Set will display registration data
in the upper half of the screen. See
Figure 24 below.
Figure 24 CALL CONTROL Screen with Registration Data Displayed
This is typical data
received when a
mobile has
successfully registered.
Registra.tif