Filter
Top Products
11
Ethernet Communication
Setting up the eBase
1. Plug the power cord into the power adapter.
2. Plug the power connector cable into the power
connector on the back of the eBase.
3. Plug the A/C power cord into a standard wall outlet.
The COMM LED flashes red.
Note: When searching for a network, the 9700 terminal looks for
a USB connection first, and then an Ethernet connection. If
you only require an Ethernet connection, Honeywell
recommends disconnecting the USB cable from the eBase.
Remove the Dolphin terminal from the eBase before
connecting or disconnecting the USB cable.
4. Plug the CAT-5 Ethernet cable into the RJ45
connector on the back of the eBase.
5. Plug the Ethernet cable into the network.
6. The COMM LED flashes orange while the eBase
attempts to acuire an IP address. The COMM LED
will change to a solid orange when a network
connection has been established.
Connecting the Dolphin Terminal to the
eBase
After the eBase is installed, configured, and connected to
the host computer, you must connect the Dolphin terminal
to the eBase.
1. Remove the Dolphin terminal from the eBase if it is
docked.
2. On the Dolphin terminal, tap
Start
>
ActiveSync >
Menu > Connections