Filter
Top Products
User Manual
Aolynk DR814Q ADSL2+ Broadband Router 5 Advanced Configuration
50
Example: Figure 5-14 illustrates a physical connection that requires static routes.
Figure 5-14 Network diagram for the static route configuration
In Figure 5-14, suppose that a DHCP service is configured for the DR814Q, the
gateway address is 192.200.200.1, and there is a default route to broadband access
server (BAS).A router is connected to another network segment, LAN2 (16.0.0.0/4), on
the WAN side, and the IP address of the WAN port is 192.200.200.81. To make hosts in
LAN1 access hosts in LAN2 normally, you need to create a route as below so that the
DR814Q can choose routes for packets correctly.
Figure 5-15 Example of the static route configuration
5.3.2 Dynamic Route Configuration
The static route configuration makes the DR814Q to learn route information of other
routers on the network through RIP. Click the [RIP] tab on the route setup page to enter
the dynamic route configuration page shown in Figure 5-16.