Filter
Top Products
HG232f 300Mbps Wireless Router
User Guide
7 FAQs
7-1
7 FAQs
Q 1: Can I use the router as a DHCP server?
Yes. The router incorporates the DHCP server software.
Q 2: How can I quickly restore the default settings of the router?
When the router is powered on, press and hold the Reset button for 6 or more seconds,
and then release it. The router then automatically restarts and the default settings are
restored.
Q 3: What can I do if I cannot access the router configuration page?
Step 1
Check the IP address of your computer and ensure that this IP address is in the same
network segment as the router LAN IP address.
Step 2
Ensure that your Web browser does not use a proxy server.
Step 3
Ensure that you have entered the valid user name and password used to access the router
configuration page.
If the problem persists, restore the default settings of the router.
----End
Q 4: Does the WPS function have any special requirement on the wireless
encryption settings of the router?
The WPS function can be used only when the WLAN security mode is set to WPA-PSK
or WPA2-PSK. It is recommended that you set the security mode to
WPA-PSK/WPA2-PSK.
Q 5: If my computer fails to connect to a WLAN after I press and hold the
WPS button, what should I do?
Step 1
Ensure that only one computer is connecting to the router through the WPS function at
one time.
Step 2
On the router, ensure that the wireless network function and the WPS function
implemented through the PBC method are enabled.
Step 3
Ensure that the security mode of the WLAN is set to
WPA-PSK
or
WPA2-PSK
. Note
that the WPS function of the router is forcibly disabled if the WEP encryption is used for
the WLAN.