Filter
Top Products
HX200/HX200L-2000/HX300/HX300L/HX400
1-2
1.
Safety
1.1. Introduction
The main purpose of this chapter is to describe the safety precautions for users and
operators who repair and manipulate the industrial robot.
This manual describes safety precautions for robot manipulator and controller, in
comply with the requirement of ANSI/RIA R15.06-1999, Standard for Safety,
Industrial Robots, and qualified with safety regulations. The technical description and
installation method of robot system is presented in detail at the specifications
regarding installation of robot manipulator and controller.
Every operator, who installs, replaces, adjusts, manipulates, maintains, and repairs,
must read thoroughly and fully understand the manipulation and maintenance
manual, in particular, the special attention must be paid to the WARNING symbol, the
most important marking related to the safety.
Installation, replacement, adjustment, manipulation, maintenance, and repair of robot
system must be performed by the personnel who was duly trained for these purposes,
following the indicated operating procedure.
This company is planning and carrying out the relevant training such as maintenance,
repair, and manipulation for the above operations, so robot users make sure that
robot operators should get the relevant training. And make sure that the robot
handling work should be carried out only by the operators who completed this
training course.
The Users of HR and HX industrial robots have a responsibility under the safety
relavant regulations valid in the country where the robot is installed, and a
responsibility to properly design, install, and operate the safety devices to protect
workers.
The dangerous zone of robot system, that is the working range in which the robot,
tool, and peripheral equipment are operated, must be safeguarded to prevent
workers or objects from entering the zone. If a person or object should nevertheless
enters the dangerous zone, make sure that the robot system is immediately shut
down by emergency stop system. The operators of robot system have a
responsibility to take all necessary steps to make correct installation, examination
and operation of the relevant safety devices.
This manual is provided for the utilization of HR and HX Series Manipulator models
and Hi4a controller.
Valid application and invalid environment of HR and HX Series robots are as follows.
Application