Filter
Top Products
Module test menu and hardware
configuration report
Depending on the diagnostics version level you are using,
the installed devices in the computer are verified in one of
two ways:
1. At the start of the diagnostic tests, the Module Test
Menu is displayed. Normally, all installed devices in
the computer are highlighted on the menu.
2. At the start of the diagnostic tests, the main menu
appears. From this menu, select System Info then
select Hardware Configuration from the next menu.
Normally, all installed devices in the computer are
highlighted on this report.
If an installed device is not recognized by the diagnostics
program:
The diagnostic code for the device is not on the
diagnostic diskette. Run the diagnostics provided
with that device.
The missing device is defective or it requires an
additional diskette or service manual.
An unrecognizable device is installed.
A defective device is causing another device not to be
recognized.
The SCSI controller failed (on the system board or
SCSI adapter).
Use the procedure in “Undetermined problem” on
page 206 to find the problem.
If a device is missing from the list, replace it. If this does
not correct the problem, use the procedure in
“Undetermined problem” on page 206.
IntelliStation - 6866 127