IBM 6866 Personal Computer User Manual


 
Preparing the rack enclosure
Parts needed:
Two slide bracket assemblies
Two slide rails (fitted to system unit)
One cable-management arm
Ten long screws
Ten cage nuts
Installation template
Attention
To ensure cabinet stability, install computers in the
rack enclosure starting from the bottom.
Attention
This procedure requires two people.
To attach the mounting hardware to the rack enclosure:
1. Mark the positions of the slide brackets on the
mounting rails on the rack enclosure:
a. Position the template on the front mounting rail
on the rack enclosure, aligning the holes.
Secure the template in place with tape.
b. Mark the holes for the slide brackets and cage
nuts.
c. Remove the tape from the mounting rails, and
attach the template to the rear mounting rails.
Mark the locations for the slide brackets and
cage nuts.
Notes
1. Align the slide brackets correctly, or the
installation cannot be completed.
2. The slide rails have four screws each to
allow for length adjustment.
2. Install the cage nuts in the marked positions as
shown.
176 IBM PC 300/IntelliStation Vol 3 HMM