Filter
Top Products
cable-management arm mounting panel and
cage nut; then, tighten the screws.
Note
1. You can choose to wait to attach the
cable-management arm to the rack
until after you have attached the other
end of the cable-management arm to
the computer.
2. To facilitate alignment of the
cable-management arm, be sure to
insert the screws through the first and
fourth holes, as shown.
Installing the computer in the rack
enclosure
Parts needed:
Four long screws
Two cage nuts
One cable-management arm
Cable ties
To install the computer into the rack enclosure:
1. Install a cage nut in each front mounting rail in the
marked positions, as shown.
2. Position the computer horizontally, with the 3.5-inch
drive bays on the top.
3. Align the inner slides of the computer with the slide
rails; then, slide the computer onto the outer slide,
until the slide rails click into place.
180 IBM PC 300/IntelliStation Vol 3 HMM