IBM 6866 Personal Computer User Manual


 
DANGER
To avoid a shock hazard, do not connect or
disconnect any cables or perform installation,
maintenance, or reconfiguration of this
product during an electrical storm.
To avoid shock hazard:
The power cord must be connected to a
properly wired and earthed receptacle.
Any equipment to which this product will
be attached must also be connected to
properly wired receptacles.
When possible, use one hand to connect or
disconnect signal cables to prevent a
possible shock from touching two surfaces
with different electrical potentials.
Electrical current from power, telephone, and
communications cables is hazardous. To
avoid shock hazard, connect and disconnect
cables as described following when
installing, moving, or opening covers of this
product or attached devices.
To Connect
1. Turn Everything OFF.
2. First, attach all cables
to devices.
3. Attach signal cables to
receptacles.
4. Attach power cord(s) to
outlet.
5. Turn device ON.
To Disconnect
1. Turn Everything OFF.
2. First, remove power
cord(s) from outlet.
3. Remove signal cables
from receptacles.
4. Remove all cables
from devices.
NOTE: In the UK, by law,
the telephone cable must be
connected after the power
cord.
NOTE: In the UK, the power
cord must be disconnected
after the telephone cable.
Related Service Information 309