Filter
Top Products
Removal and Replacement 3-59
Contact Strips (Models 340, 34H, 350, 355, 360/36T, 365,
370/37T, 375)
Removal
1.. Set the power switches of the system unit to Off.
2.. Do the removal procedure in “Rear Cover” on page 3-3.
3.. Do the removal procedure in “Top Cover” on page 3-4.
4.. Peel off the contact strip from the bottom side of the top cover, if this is the one to be
replaced. Go to the replacement procedure following.
5.. Do the removal procedure in “Power Supply” on page 3-16.
6.. Peel off the contact strip from the right side of the base.
Replacement
1.. Clean off any tape remaining from the old contact strip.
2.. Remove the release paper from the new contact strip.
3.. Press the contact strip to the cover in the location shown. The adhesive requires 24
hours to reach full strength. Use extra care during reassembly.
4.. Replace parts in reverse order.
Top Cover
Area Location
340 and 350
only
Power
Supply Area
Location