Filter
Top Products
To start the lmcp daemon:
root% /etc/methods/startatl
To test whether lmcp daemon is configured and working correctly:
% mtlib -l<lmcpDevice> -qL
where lmcpDevice is usually /dev/lmcp0.
To test ability to use lmcp daemon to mount a tape:
% mtlib -l/dev/lmcp0 -m -V<tapeLabel> -x<deviceNumber>
Test ability to dismount the tape:
% mtlib -l/dev/lmcp0 -d -V<tapeLabel> -x<deviceNumber>
To automatically start the lmcp daemon after system reboot, add /etc/methods/startatl to the
/etc/inittab file
Refer to Section 5.2.8.2: 3494 PVR Specific Configuration of the HPSS Management Guide for more
information.
4.3.4. STK
For an STK tape library:
• If using an STK tape library, configure the ACSLS and SSI software properly and verify that
it is working correctly.
To test the ability to mount and dismount a tape in an STK library, use the stk_ctl utility.
To mount a tape:
% stk_ctl mount <driveSpec> <tapeLabel>
where driveSpec is four integers separated by commas (no spaces), identifying the ACS,
LSM, panel, and drive (e.g., 0,0,1,2).
To dismount a tape:
% stk_ctl dismount <driveSpec>
To query a drive:
% stk_ctl query <driveSpec>
Refer to Section 5.2.8.6.: STK PVR Specific Configuration and Section 5.2.8.7: STK RAIT PVR
Configuration (both in the HPSS Management Guide) for more information.
4.3.5. AML
The AML PVR is supported by special bid only.
HPSS Installation Guide July 2008
Release 6.2 (Revision 2.0) 123