Filter
Top Products
5.8.3. Construct and Build the HPSS HDM Source Tree
XFS is not supported in HPSS 6.2. XFS references have been left in the HPSS
documentation to support the option of re-enabling XFS in future releases.
This section describes the procedures to extract the HDM source code from the HPSS base source
tree and to build the HDM binaries.
5.8.3.1. Construct the HPSS HDM Source Tree
The HPSS HDM source tree can be extracted from the HPSS base source tree. To construct the HDM
component source tree, the following steps must be performed:
On the machine where the HPSS base source tree is installed:
1. Log on as root.
2. Change directory to the HPSS base source tree (the default location is /opt/hpss).
3. Review the Makefile.macros file.
4. Ensure that the target directory tree (where the source tree will be constructed) is empty.
5. Issue the following command:
% make BUILD_ROOT=<HDM source tree directory> build-hdm
On the machine where the HPSS HDM source tree will be constructed:
1. Log on as root.
2. Copy the tar file for the Mover/Client source to the Mover/Client machine.
3. Change directory to the /opt/hpss directory.
4. Untar the tar file for the Mover/Client source into the /opt/hpss directory.
5.8.3.2. Build the HPSS HDM Source Tree
To compile the HPSS HDM sources, the following steps must be performed:
1. Change directory to /opt/hpss directory.
2. Review the /opt/hpss/Makefile.macros file. This file defines the "make" environments and
options for the HPSS software compilation. Ensure that the environments and options are
specified properly before running the "make hdm" command.
5.9. Supporting Both Unix and Kerberos Authentication for SSM
Once security services have been configured for your system (see Section 5.3.1.4: Configure HPSS
Security Services on page 143 for details), if both Unix and Kerberos have been set up, it is possible
to configure your system to support both Unix and Kerberos authentication for the SSM. If you can
login to the system using the SSM gui, you can use it to set this up, as described in Section 3.3.1:
Configuring the System Manager Authentication for SSM Clients of the HPSS Management Guide. If
that is not an option because no available authentication mechanism is configured, you can use the
procedure that follows to set up support for both authentication mechanisms. The combination of
HPSS Installation Guide July 2008
Release 6.2 (Revision 2.0) 175