Filter
Top Products
This panel allows you to install the DB2 software, HPSS software (option starting in 6.2.1), and
HPSS documentation. Perform the following steps to install the software:
1. To install DB2, check the 'Install DB2' checkbox. Click on the 'Source Path' button and
select the directory that contains the DB2 filesets you wish to install. DB2 software will be
installed in the /usr/opt/db2_08_01 (AIX) or /opt/IBM/db2/v8.1 (Linux) directory.
2. For 6.2.0, the HPSS software and documentation should already be installed according to the
installation step in section 5.3.2.1. Installing from CD will be an option starting in 6.2.1.
3. For 6.2.0, the hpssuser utility should be used to package the HTML files for delivery to each
hpssgui machine or to a common shared file system on a remote node. Installing from CD
will be an option starting in 6.2.1.
To provide the SSM Help facility, the HTML files from the HPSS documentation
must be accessible from the node where the hpssgui program runs. The files may be
installed on a shared file system available to all nodes, or the hpssuser utility may be
used to package the HTML files for delivery to each hpssgui machine.
4. Click the 'Install Software' button to install the selected software.
5. If the installation was a success, you should see the following message in the command
output window:
## run command exited with status 0
Click the 'Done' button on the Command Output window to close the window.
5.3.2.3. Set Up DB2 Permanent License
This section describes the procedure to create the DB2 permanent license and to specify the number
of processors licensed for the secondary subsystem machine.
To create a permanent DB2 license, issue the following commands:
HPSS Installation Guide July 2008
Release 6.2 (Revision 2.0) 162