Filter
Top Products
"Configuration" icon and then the "Other Services" icon. The following window will be
shown:
2. Click on the "Configure Other Services" button to complete the configuration of the
Secondary Subsystem Machine. If the configuration was a success, you should see the
following message in the command output window:
## run command exited with status 0
Click the 'Done' button on the Command Output window to close the window.
5.3.3. Install and Configure HPSS – Mover/Client Machine
For the Mover/Client machine, the following configuration steps must be performed:
• Install Mover/Client source code
• Install configuration bundle
• Create /var/hpss subdirectories
• Modify Kerberos configuration, if necessary
• Check time and IP address
The following sections describe the procedure to perform the above steps.
5.3.3.1. Install Mover/Client source code
Follow the instruction in on page 174, section 5.8.2 Construct and Build the HPSS Mover/Client
HPSS Installation Guide July 2008
Release 6.2 (Revision 2.0) 168