Filter
Top Products
configuration step. Other HPSS utilities are available to administer these HPSS
configuration files. See section 2.2.2: Security Mechanisms in the HPSS Management Guide
for more information. To use the HPSS configuration files, select the "Enable local Unix
Passwd Files" checkbox. The default names for the files should be used as displayed.
7. Select the "Configure Server accounts" checkbox to create UNIX accounts for HPSS servers.
8. Click on the "Configure Security Services" button at the bottom of the screen to perform the
specified security configuration.
9. If the configuration was a success, you should see the following message in the command
output window:
## run command exited with status 0
Click the 'Done' button on the Command Output window to close the window.
5.3.1.4.2. Configure Kerberos Authentication and UNIX Authorization
From the "Root Subsystem Machine" submenu in the left panel, click on the "Configuration" icon
and then the "Security Services" icon. Perform the following steps using the right panel :
1. Select the "Configure Authentication Service" checkbox. Set the "Authentication Service" to
"Kerberos".
2. The fields to be configured are as displayed on the screen shown:
3. Review and modify (if necessary) the following authentication fields:
• Kerberos Install Path. The pathname where Kerberos is installed. The default
directory is /usr/kerberos.
HPSS Installation Guide July 2008
Release 6.2 (Revision 2.0) 146