Filter
Top Products
check every bitfile descriptor in the 6.2 system. The -f and -l options check only the first and last
number of bitfile descriptors provided with these options. To invoke this utility, see the usage below:
db_convert_address_check
-g <SFS Global Config File>
-db <DB Names Text File>
-ss <SSId Text File>
-s <Subsystem Id>
[-a] (check all files)
[-f <Number>] (check first <Number> files)
[-l <Number>] (check last <Number> files)
6.3.14.5. Terminate Scripting Session
Terminate the scripting session. This ends the process for converting HPSS 4.5 specific metadata.
Proceed to Section 6.3.17: Perform the DCE Export: hpss_dce_export on page 215 to continue the
conversion to HPSS 6.2.
% exit
6.3.15. Upgrade from HPSS 5.1 to HPSS 6.2
Only follow procedures in this section if upgrading a system from HPSS 5.1 to HPSS 6.2.
To upgrade HPSS from version 5.1, run the hpss_md_convert_51 utility. The hpss_md_convert_51
program is a menu driven program that converts the 5.1 HPSS metadata to HPSS 6.2 metadata. It
does not modify HPSS 5.1 metadata so that it is possible to revert to the HPSS 5.1 system during any
point in the conversion process. The metadata changes are performed by renaming the 5.1 HPSS table
by pre-pending the original table name with “PRE62_” and creating a new HPSS 6.2 table. The
conversion then reads information from the HPSS 5.1 tables, makes the necessary metadata
modifications in memory, and inserts the new metadata into the HPSS 6.2 table. In cases where a
function is no longer supported, the pre-6.2 table is renamed pre-pending the original table name with
"PRE62_", but the new table in HPSS 6.2 is not populated with metadata. All steps must be followed
in order to successfully convert the metadata from HPSS 5.1 to HPSS 6.2.
To begin the metadata conversion, run the conversion program hpss_md_convert_51:
% hpss_md_convert_51
HPSS 5.1 - 6.2 Metadata Conversion
1) Rename old tables
2) Create new tables
3) Convert Gatekeeper config table
4) Convert Location Server policy table
5) Convert Server Generic config table
6) Convert DMG config table
7) Convert Mover Device table
enter number or RET to exit:
If errors occur, see Section 6.4: Metadata Conversion Troubleshooting Procedures on page 227 of
this document before contacting your HPSS customer support representative.
Successful output for each option follows:
HPSS Installation Guide July 2008
Release 6.2 (Revision 2.0) 213