Filter
Top Products
44 Nortel Networks L2/3 Ethernet Switch Module for IBM Eserver BladeCenter
6.1 IBM Eserver BladeCenter system
In this section, we discuss the stages of preparing IBM Eserver BladeCenter for operation.
6.1.1 Management Module firmware
After the required hardware has been installed in your IBM Eserver BladeCenter, you
should update the Management Module using IBM Eserver® BladeCenter - Management
Module Firmware Update Version 1.18 or later. To acquire the firmware, go to:
http://www.ibm.com/pc/support/site.wss/document.do?lndocid=MIGR-54939
Be sure to read the notes that are associated with the firmware installation. You can also
search for the latest firmware version at:
http://www-1.ibm.com/servers/eserver/support/bladecenter/index.html
Follow the installation and setup instructions in the README file. You only need to install the
files with the .pkt extension (see Figure 6-1). After the installation, you must restart the
Management Module.
Figure 6-1 Management Module firmware update files