Filter
Top Products
Getting Started - RAID Array 410 for Windows NT – Intel
2–2 EK–SMRAC–IG. C01
You need the following before you begin:
• The appropriate host adapter (SWIA3-BB or SWXA3-BC). Use precautions to protect the
board from static discharge.
• Your computer system hardware manual
• Host adapter User’s Guide
• Appropriate tools to service your computer
• The SCSI cable (BN21K-05), with a right angle high density 68-pin connector on one end
and a straight high density 68-pin connector on the other
• Media labeled RAID 300, 400 Series WNT Intel Drivers (contains the HSZDISK.SYS
driver)
Refer to your computer system manual for any additional reference information on installing
a host adapter.
2.1.1 Preparing to Install the Host Adapter
Before installing the adapter in your host system, take precautions to protect the board from
electrostatic discharge.
CAUTION
To protect the board from static discharge, always use proper ESD
procedures. In addition, do not remove the board from its anti-
static protective cover until you are ready to install the adapter.
Install the host adapter by performing the following steps:
1. Shut down your operating system.
2. When the system has halted, power down the host computer and all attached peripherals.
Disconnect power cables from the host computer.
WARNING
Failure to remove power from the host computer and peripherals
can introduce a personal hazard, or can result in damage to the
host computer or loss of stored data.
2. Open the computer to gain access to the motherboard, and locate an appropriate available
slot to install the adapter. Refer to your computer system manual for assistance in how to
gain access to the mother board and for identifying the appropriate slot in which to install
the adapter. Refer to your host adapter user manual for any guidelines or restrictions re-
garding slot selection for the adapter.
2.1.2 Installing the Host Adapter
The following steps must be performed to successfully install the host adapter:
1. Install the host adapter board in your computer; the board connector is held in place with
the screw you removed from the blank panel. Ensure that the board end plate metal tab
aligns in the computer chassis opening properly; otherwise the adapter will not seat
properly.
2. Replace your host computer covers; refer to your host computer manual for additional in-
formation, if necessary.