Filter
Top Products
46 Intel® 41110 Serial to Parallel PCI Bridge Design Guide
Circuit Implementations
10.1.1 PCI Analog Voltage Filters
The following filter circuit is recommended for the PCI interface. Three separate, identical
versions of this circuit should be placed on the system board, one for each VCCAPCI[2:0] pin on
the 41110.
Figure 22. PCI Analog Voltage Filter Circuit
Note: Three of these PCI filter circuits must be placed on the system board, one for each of the
VCCAPCI[2:0] pins on the 41110.
• Place C as close as possible to package pin.
• R must be placed between VCC15 and L.
• Route VCCPCI[x] and VSS as differential traces.
• VCCPCI[x] and VSS traces must be ground referenced (No VCC15 references).
• Max total board trace length = 1.2”.
• Min trace space to other nets = 30 mils.
10.1.2 PCI Express Analog Voltage Filter
Figure 23 shows the PCI Express Analog Voltage Circuit.
Serial to
Parallel PCI
Bridge