Filter
Top Products
58 Intel® 41110 Serial to Parallel PCI Bridge Design Guide
Design Guide Checklist
CFGRETRY
Input pin to configure 41110 to retry configuration
accesses on it's PCI Express interface.
• To retry configuration accesses to the 41110, pull high to
3.3V through a 2K
Ω resistor.
• To allow configuration accesses to the 41110, ground
this pin through a 2K
Ω resistor.
A_TEST1,
A_TEST2,
A_PME#,
A_STRAP[3],
A_STRAP[4],
A_STRAP[5],
These signals REQUIRE an external pull-up, 8.2KΩ to
3.3V.
CMODE This signal requires an external pull-up, 8.2KΩ to 3.3V.
In normal operating mode, this
pin must be tied high.
Table 22. SMBus Interface Signals
Signal Recommendations Reason/Impact
SMBCLK Connect to VCC33 through an 8.2KΩ pullup resistor.
SMBDAT Connect to VCC33 through an 8.2KΩ pullup resistor.
SMBUS[5],
SMBUS[3:1]
SMBus addressing:
Bit 7----------------’1’
Bit 6----------------’1’
Bit 5---------------SMBUS[5]
Bit 4----------------’0’
Bit 3---------------SMBUS[3]
Bit 2---------------SMBUS[2]
Bit 1---------------SMBUS[1]
Use 8.2KΩ resistors as pullups to VCC33 for a ‘1’ and
as pulldowns to ground for a ‘0’ to set the SMBus
address.
Sampled on the rising edge of
PERST#.
Table 21. Miscellaneous Signals
Signals Recommendations Reason/Impact