Intel 460T Switch User Manual


 
26
CHAPTER 3
Intel Express 460T Standalone Switch Users Guide
To install and configure a new switch for
management
1 Start Intel Device View. The Device Install Wizard appears. If it doesnt
appear, click Install from the Device menu or double-click the
appropriate MAC address in the Device Tree under Unconfigured
Devices. (The MAC address is located on the rear of the switch.)
2 On the Device Install Wizard - Start screen, click Next.
3 On the Device Install Wizard - MAC Address screen, click the MAC
address of the new switch and then click Next.
4 Follow the instructions in the wizard to assign an IP address and a name
to the switch.
Using the Device Tree
When you start Intel Device View, the Device Discovery service begins
searching for supported Intel network devices on your network. As it
discovers devices, the Device Discovery service adds an icon for each
device to the Device Tree on the left side of the screen.
NOTE
The 460T sends BootP requests
for several minutes; after that
time, if no IP has been entered,
the switch stops sending the
request and continues to boot.