Filter
Top Products
51
On-Chip Primary/Secondary PCI IDE:
The integrated peripheral controller contains an IDE interface that
supports a single IDE channels. Select Enabled to activate the
channel.
USB Keyboard Support:
Select Enabled if your system contains a Universal Serial Bus
(USB) controller and you have a USB keyboard. The available
choices are Enabled, Disabled.
Init Display First:
This item allows you to decide to active whether PCI Slot or
on-chip VGA first The available choices are PCI Slot, Onboard .
KBC Input Clock:
The input clock setting of your onboard keyboard controller is set
from here.
Onboard FDC Controller:
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install
and-in FDC or the system has no floppy drive, select Disabled in
this field. The available choices are Enabled, Disabled.
Onboard Serial Port 1/2:
This item allows you to determine access onboard serial port 1/2
controller with which I/O address. The available choices are
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select:
This option allows you to configure the infrared interface modes
(IrDA, ASKIR (an IrDA-compliant serial infrared) port, and
Normal) generated from the second serial port. Only when set to
ASKIR mode will the options RxD. TxD Active and IR
Transmission delay activate for configuration. Disabling the
Onboard Serial Port 2 setting automatically removes the UART
Mode Select option from the options list.
UART2 Duplex mode:
Select the value required by the IR device connected to the IR
port. Full-duplex mode permits simultaneous two-direction
transmission. Half-duplex mode permits transmission in one
direction only at a time. The available choices are Half, Full.
RxD, TxD Active:
This item allows you to determine the active of RxD, TxD. The
available choices are “Hi, Hi”, “Lo, Lo”, “Lo, Hi”, “Hi, Lo”.