Filter
Top Products
52 Intel Server Board S875WP1-E Product Guide
Installing an AGP Card
Follow these instructions to install an AGP card:
1. Observe the precautions in "Before You Begin" on page 39.
2. Place the card in the AGP connector.
3. Press down on the card until it is fully seated in the AGP connector. A retention notch on the
card will snap into place around the retention pin on the lever that is marked “A” in the figure
below.
4. Secure the card’s metal bracket to the chassis back panel with a screw.
TP00191
A
Figure 17. Installing the AGP Card
Removing the AGP Card
Follow these instructions to remove the AGP card from the server board:
1. Observe the precautions in "Before You Begin" on page 39.
2. Remove the screw that secures the card’s metal bracket to the chassis back panel.
3. Pull back on the retention mechanism lever (marked “A” in the figure above to release the
retention pin from the notch in the card.
4. Pull straight up on the card to pull it from the socket.