Filter
Top Products
Configuration Software and Utilities 75
Table 22. Peripheral Configuration Submenu (continued)
Feature Options Description
Parallel Port
• Disabled
• Enabled
• Auto (default)
Configures the parallel port.
Auto assigns LPT1 the address 378h and the
interrupt IRQ7.
An * (asterisk) displayed next to an address indicates a
conflict with another device.
Mode
• Output Only
• Bi-directional
(default)
• EPP
• ECP
Selects the mode for the parallel port. Not available if the
parallel port is disabled.
Output Only operates in AT-compatible mode.
Bi-directional operates in PS/2-compatible mode.
EPP is Extended Parallel Port mode, a high-speed
bi-directional mode.
ECP is Enhanced Capabilities Port mode, a high-speed
bi-directional mode.
Base I/O Address
• 378 (default)
• 278
This feature is present only when Parallel Port is set to
Enabled
Specifies the base I/O address for the parallel port.
Interrupt
• IRQ 5
• IRQ 7 (default)
This feature is present only when Parallel Port is set to
Enabled
Specifies the interrupt for the parallel port.
DMA
• 1
• 3 (default)
This feature is present only when Parallel Port Mode is set
to ECP
Specifies the DMA channel.
10/100 NIC
• Disabled
• Enabled
(default)
Enables or disables the on-board LAN#1 device.
Gigabit NIC
• Disabled
• Enabled
(default)
Enables or disables the on-board LAN#2 device.
ATI Rage XL Video
• Disabled
• Enabled
(default)
Enables or disables the on-board ATI* Rage XL video
controller.
Promise PDC20319
S150 TX4
• Disabled
• Enabled
(default)
Enables or disables RAID support.